2021 Chevrolet Camaro LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Engine Control Module Replacement

GM4282814Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection
  2. Engine Wiring Harness Fuse Block Bracket Replacement
1 Engine Control Module Bracket Retaining Tab [2x]
2 Engine Control Module Bracket
3 Engine Control Module
WARNING:

Refer to Safety Glasses Warning .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.