2021 Chevrolet Camaro LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. GM4161889Courtesy of GENERAL MOTORS COMPANY

    Brake Pressure Modulator Valve Assembly (1) - Install

  2. GM4161887Courtesy of GENERAL MOTORS COMPANY

    Brake Pressure Modulator Valve Bracket Nut (1) - Install and tighten 7 N.m (62 lb in) [3x]

  3. GM4161886Courtesy of GENERAL MOTORS COMPANY

    Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)

  4. GM4161884Courtesy of GENERAL MOTORS COMPANY

    Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)

  5. GM4161883Courtesy of GENERAL MOTORS COMPANY

    Left Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)

  6. GM4161882Courtesy of GENERAL MOTORS COMPANY

    Right Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)

  7. GM4161880Courtesy of GENERAL MOTORS COMPANY

    Left Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)

  8. GM4161879Courtesy of GENERAL MOTORS COMPANY

    Right Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)

  9. Connect the EBCM electrical connector.
  10. Bleed the brake system. Antilock Brake System Automated BleedΒ 
  11. Plenum Front Panel - Install - Plenum Front Panel Replacement (LTG LGX) , or Plenum Front Panel Replacement (LT1 LT4)
  12. Program the EBCM. Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.