2021 Chevrolet Camaro LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Removal Procedure

CAUTION:

Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

  1. Place the ignition switch in the OFF position.
  2. Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
  3. Windshield Washer Solvent Container Filler Tube Replacement - Remove
  4. Disconnect the EBCM electrical connector.
  5. GM4161877Courtesy of GENERAL MOTORS COMPANY

    Electronic Brake Control Module Bolt (1) - Remove [4x]

  6. GM4161878Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT pry the components apart.

    Electronic Brake Control Module (1) - Remove

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.