Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2020 Chevrolet Traverse LFACTORY OEM SERVICE PROCEDURE

Liftgate Side Sensor Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Preliminary Procedure
Open the liftgate.

Liftgate Side Sensor Retainer [5x]

Liftgate Side Sensor

Procedure

Using a trim type tool, release the retainers.
Disconnect the electrical connector.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.