Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Testing
- Ignition OFF, disconnect the coax cable connector at the T4T Wireless Communication Antenna - WLAN and at the A11 Radio.
- Verify the coax cable passes the coax cable component test. Refer to Component Testing.
- If the coax cable does not pass the test
Replace the coax cable
- Go to next step: If the coax cable passes the test
- If the coax cable does not pass the test
- Test or replace the T4T Wireless Communication Antenna - WLAN.
- Verify DTC B248A is not set.
- If DTC B248A is set
Replace the A11 Radio.
- Go to next step: If DTC B248A is not set
- If DTC B248A is set
- All OK.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.