2019 Chevrolet Volt LTFACTORY OEM SERVICE PROCEDURE

Communication Interface Module Replacement

WARNING: This page is about a different car, the 2019 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
GM5001845Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Refer to Battery Disconnect Warning .

Preliminary Procedures

  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
  2. Remove the driver front seat. Front Seat Removal and Installation .
1 Communication Interface Module

Procedure

  1. Disconnect the electrical connector.
  2. Remove the communication interface module from the communication interface module bracket.
  3. Install the driver front seat. Front Seat Removal and Installation
  4. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
  5. For programming and set up procedures, refer to Control Module References .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.