2019 Chevrolet Traverse LS, 4WDFACTORY OEM SERVICE PROCEDURE

Replace and Program Control Module

To program a replacement K71 Transmission Control Module (TCM), perform the following procedure:

  1. Replace the K71 Transmission Control Module.
  2. Install EL-49642Β  SPS programming support tool
  3. Access the Service Programming System (SPS) and follow the on-screen instructions.
  4. Perform one of the following SPS Programming functions:
      NOTE:

      If both controller options below are listed, select K71 Transmission Control Module

    • K20/ K71 Engine and Transmission Control Modules and follow the on-screen instructions
    • K71 Transmission Control Module and follow on-screen instructions.
  5. Perform the Refresh Characterization Data at the MCVM Characterization procedure, follow the on-screen instructions.
  6. Perform the Vehicle Setup, follow the on screen instructions.
  7. With a scan tool, clear DTCs from the K71 Transmission Control Module.
  8. Ignition OFF for 2 minutes.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.