Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2019 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Forward Collision Alert Display Replacement

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Forward Collision Alert Display

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Keyless Entry Control Module Bracket Replacement
1	Forward Collision Alert Display Assembly Procedure Use a flat bladed plastic tool when removing the forward collision alert display assembly from the instrument panel upper trim panel. Disconnect the electrical connector.
2	Forward Collision Alert Display Screw (Qty: 2) CAUTION: Refer to Fastener Caution .
3	Forward Collision Alert Display Module
4	Forward Collision Alert Display Bezel

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.