Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Chevrolet Malibu LSFACTORY OEM SERVICE PROCEDURE
Programming a New Control Module
To program a new control module, perform the following procedure:
- Install the special tool: EL-49642 SPS Programming Support Tool
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K114B Hybrid/EV Powertrain Control Module 2 - Programming and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs"
- With a scan tool, perform the Clear Secured High Voltage DTCs and follow the on-screen instructions.
- With a scan tool, Clear All DTCs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.