Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
K188 Human Machine Interface Control Module Bypass Module X1 (UVH)
2018 Chevrolet Traverse LS, 4WDSECTION K188 Human Machine Interface Control Module Bypass Module X1 (UVH)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray Name | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | 19333221 | EL-35616-58 (BK) | J-38125-553 | Not Available | Not Available | Not Available | Not Available |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 0.35 | RD/GN | 2173 | 12V Regulated Supply Voltage 2 | I | - |
| 2 | 0.35 | GY/GN | 70 | RAP Relay Switch Control | I | - |
| 3 | 0.35 | GN/WH | 7527 | Local Interconnect Network Serial Data Bus 5 | I | - |
| 4 | - | - | - | Not Occupied | - | - |
| 5 | 0.35 | BK | 1550 | Ground | I | - |
| 6 | 0.35 | GY/YE | 6972 | Camera Signal 2 + | I | - |
| 7 | - | - | - | Not Occupied | - | - |
| 8 | 0.35 | GY/YE | 6972 | Camera Signal 2 + | I | - |
| 9 | 0.35 | GN/WH | 24 | Backup Lamp Control | I | - |
| 10 - 17 | - | - | - | Not Occupied | - | - |
| 18 | 0.35 | WH/BU | 6973 | Camera Signal 2 | I | - |
| 19 | 0.35 | BARE | 6974 | Camera Low Reference | I | - |
| 20 | 0.35 | WH/BU | 6973 | Camera Signal 2 | I | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.