Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Electronic Brake and Traction Control Module Bracket - Install - Electronic Brake and Traction Control Module Bracket Replacement
Electronic Brake Control Module with Brake Pressure Modulator Valve Assembly (1) - Install
- CAUTION:
Brake Pressure Modulator Valve Bracket Bolt (1) - Install and tighten 22 N.m (16 lb ft)
Left Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Right Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Right Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Left Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
- Connect the EBCM electrical connector.
- Brake Pressure Modulator Valve Master Cylinder Reservoir Rear Pipe - Install - Brake Pressure Modulator Valve Master Cylinder Reservoir Rear Pipe Replacement
- Brake Pressure Modulator Valve Master Cylinder Reservoir Front Pipe - Install - Brake Pressure Modulator Valve Master Cylinder Reservoir Front Pipe Replacement
- Reposition and install the radiator surge tank. - Radiator Surge Tank Replacement (LFY)Radiator Surge Tank Replacement (LTG)
- Bleed the brake system. Antilock Brake System Automated Bleed
- Program the EBCM. Control Module References
- Center the steering angle sensor. Steering Wheel Angle Sensor Centering
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.