Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clutch Position Learn
This procedure can be carried out in case improper clutch calibration is the suspected cause of system malfunction.
The procedure is also part of the Configuration & Setup procedure and therefore does not need not to be carried out additionally.
- Perform the scan tool learn/reset function: Clutch Position Learn
- Select: Module Diagnostics
- Select: Transmission Control Module
- Select: Configuration/Reset Functions
- Select: Clutch Position Learn
- Follow the instructions on the scan tool.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.