SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018SPARK LS, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISDATA COMMUNICATIONS SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE BRACKET REPLACEMENT
2018 Chevrolet Spark LS, Standard Trans

Body Control Module Bracket Replacement

2018 Chevrolet Spark LS, Standard TransSECTION Body Control Module Bracket Replacement
GM4051330Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel knee bolster assembly. Refer to Instrument Panel Knee Bolster Replacement .
  3. Detach the instrument wiring harness junction block from the I/P tie bar.
  4. Remove the steering column lower support bracket bolt and upper support bracket nuts and lower the steering column to access the body control module bracket nuts. Refer to Steering Column Replacement .
1 Body Control Module Bracket Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
6.5 N.m (58 lb in)
2 Body Control Module Bracket
Procedure 
After removing the bracket transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.