Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Chevrolet Spark LS, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE
Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)
NOTE:
Due to continuous improvements, the on screen selections may vary from instructions below.
To program a replacement or an existing Front View Camera Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Setup (if this option is available) and follow the on-screen instructions.
- At the end of programming, choose the "Clear DTCs" function on the SPS screen.
- Following K109 Frontview Camera Module replacement and reprogramming, the module must be calibrated..
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.