2018 Chevrolet Spark ACTIV, Standard TransFACTORY OEM SERVICE PROCEDURE

Sunroof Module Assembly Replacement

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Sunroof Module Assembly
GM4025132Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the sunroof window. Refer to Sunroof Window Replacement .
  2. Remove the headliner. Refer to Headlining Trim Panel Replacement .
  3. Disconnect the sunroof harness electrical connectors.
  4. Disconnect the drain hoses from the sunroof frame. Do not remove the drain hoses from the vehicle, disconnect the drain hoses at all the corners of the sunroof frame spigot only. Refer to Sunroof Housing Front Drain Hose Replacement  and Sunroof Housing Rear Drain Hose Replacement .
1 Sunroof Module Bolts (Qty :8)
CAUTION: Refer to Fastener Caution .

Procedure

  1. With an assistant, lower and remove the sunroof module assembly from the vehicle.
  2. Place the sunroof assembly on a clean dry surface.
  3. Transfer all necessary components to the new module assembly.
2 Sunroof Module Assembly

Procedure

  1. Transfer all necessary components
  2. Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment 
  3. Verify the proper operation of the sunroof before securing the headliner.
  4. Ensure the motor/actuator initialization/teach process has been done. Refer to Sunroof Motor/Actuator Initialization/Teach Process .
  5. Water test vehicle before installing the trim to ensure No leaks.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.