Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Volt PremierFACTORY OEM SERVICE PROCEDURE
Circuit/System Verification
- Vehicle ON, verify no DTCs are set.
- If DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If no DTCs are set
- If DTCs are set
- With the charge cord NOT connected to the vehicle battery charger receptacle, verify the vehicle plug-in charging status indicators are OFF.
- If the vehicle plug-in charging status indicators are not OFF with the charge cord disconnected from the vehicle
Refer to Plug-In Charging Indicator Malfunction .
- If the vehicle plug-in charging status indicators are OFF
- If the vehicle plug-in charging status indicators are not OFF with the charge cord disconnected from the vehicle
- Vehicle OFF and connect the charge cord to the vehicle battery charger receptacle.
- Verify the vehicle charge status indicators are operating properly.
- If the vehicle charge status indicator is solid yellow
Refer to Circuit/System Testing.
- If the vehicle charge status indicator is not illuminated
- Vehicle ON.
- Verify the Charge Cord Connected message is displayed in the instrument panel/message center.
- If the Charge Cord Connected message is displayed, refer to Plug-In Charging Indicator Malfunction .
- If the Charge Cord Connected message is NOT displayed, refer to Circuit/System Testing.
NOTE:Vehicle must be ON and not in Service Mode for message operation.
- If the vehicle charge status indicator is operating properly
- If the vehicle charge status indicator is solid yellow
- All OK.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
