2017 Chevrolet Volt PremierFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Remove Front Floor Rear Console Side Trim Panel Replacement - Left Side
  2. Remove Front Floor Rear Console Side Trim Panel Replacement - Right Side
    3. Fig 1: Front Floor Console Bracket Bolts
    GM4137991Courtesy of GENERAL MOTORS COMPANY
  3. Remove Front Floor Console Bracket Bolt (1)
    4. Fig 2: Front Floor Console Housing Assembly And Radio Cooling Duct
    GM4137992Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the Front Floor Console Housing Assembly (1) from the Radio Cooling Duct (2).
  5. Disconnect the electrical connector.
  6. Remove the Front Floor Console Housing Assembly (1) from the Front Floor Console Assembly.
    7. Fig 3: Front Floor Console Accessory Bracket, Wireless Charging System Module And Bracket Bolts
    GM4137993Courtesy of GENERAL MOTORS COMPANY
  7. Remove Front Floor Console Bracket Bolt (1)
  8. Separate the Front Floor Console Accessory Bracket (2) from the Wireless Charging System Module (3).
  9. Transfer components as necessary.
Chapter Navigation
Return to Chapter: Wireless Charging System Module Replacement
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.