2017 Chevrolet Volt PremierFACTORY OEM SERVICE PROCEDURE

Front View Camera Replacement

Fig 1: Front View Driver Information Camera
GM4114673Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove Windshield Multifunction Sensor Mount Bracket Lower Cover. Refer to Windshield Multifunction Sensor Mount Bracket Lower Cover Replacement
1 Front View Driver Information Camera

Procedure

  1. Using a suitable plastic tool, insert the tool between the edge of the front view camera retainers and camera, turn the tool to release the retainers and rotate the camera downward.
  2. Disconnect the electrical connector.
  3. Refer to Control Module References for programming and setup information, if required.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.