2017 Chevrolet Trax LS, AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Fuel Tank Fuel Pump Module
    GM2772378Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW fuel tank fuel pump module O-ring gasket (1).
  2. Install the fuel tank fuel pump module (2).
  3. Fig 2: Fuel Tank Vent Pipe
    GM2772310Courtesy of GENERAL MOTORS COMPANY
  4. Lower the fuel pump module (2) into the fuel tank while connecting the fuel tank vent pipe (1) to the fuel pump module. Refer to Plastic Collar Quick Connect Fitting Service 
  5. Fig 3: Fuel Sender Lock Ring
    GM2770610Courtesy of GENERAL MOTORS COMPANY
  6. Install the fuel tank fuel pump module lock ring (1) to the fuel tank (2).
  7. Using the CH-45722  Tool-Fuel Sender Lock Ring and a long breaker-bar, rotate the fuel pump module lock ring (1) in a clockwise direction in order to lock the lock ring.
  8. Connect the evaporative emission hoses. Refer to Plastic Collar Quick Connect Fitting Service .
  9. Connect the fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
  10. Connect the electrical connector.
  11. Install the fuel tank. Refer to Fuel Tank Replacement .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.