2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Position the steering gear in the vehicle from the left side of the vehicle.
  2. Fig 1: Left Side Steering Gear Nuts & Bolts
    GM1860867Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.