Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the power steering pump (1) to the vehicle.
- Install the power steering pump bolts (2) and tighten to 50 N.m (37 lb ft).
- Connect the power steering gear inlet hose fitting (1) to the power steering pump and tighten to 34 N.m (25 lb ft).
- Connect the power steering fluid reservoir outlet hose (1) to the power steering pump.
- Clean any excess fluid from the vehicle and remove the drain pans.
- Install the right side catalytic convertor. Refer to Catalytic Converter Replacement - Right Side .
- Install the steering gear heat shield. Refer to Steering Gear Heat Shield ReplacementΒ .
- Install the drive belt. Refer to Drive Belt Replacement .
- Fill and bleed the power steering system. Refer to Power Steering System BleedingΒ .
- Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
CAUTION:
Refer to Fastener Caution .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
