Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Ensure that the fuel feed pipe and fuel pump fittings are clean and dry prior to assembly.
- Lubricate the pipes with silicon free engine oil, or equivalent. Adhesives, Fluids, Lubricants, and Sealers
- Position the NEW fuel feed pipe (2) to the cylinder head and high pressure fuel pump.
- Install the fuel feed pipe fitting to the high pressure fuel pump hand tight.
- Install the fuel feed pipe bolts (4).
- Tighten the bolts to 50 N.m (37 lb in).
- Tighten the fitting to 30 N.m (22 lb ft).
- Connect the fuel feed line quick connect fitting to the fuel feed pipe (2). Fuel Pipe Shield ReplacementΒ
- Inspect for leaks using the following procedure:
- Turn ON the ignition, with the engine OFF for 2 seconds.
- Turn OFF the ignition, for 10 seconds.
- Turn ON the ignition, with the engine OFF.
- Inspect for fuel leaks.
- Install the low side fuel pressure service port cap.
- Install the fuel tank cap.
- Install the high pressure pump shield. Fuel Pipe Shield ReplacementΒ
- Install the fuel injection sight shield. Fuel Injector Sight Shield Replacement
CAUTION:
Refer to Fastener Caution .
NOTE:
If a fuel leak accrues at the high pressure fuel pump, the pump will need to be replaced.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
