2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β 

Application
Thermostat Gasket
Water Outlet Housing Seal
Water Pump Seal
Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β 

Application Specification
Metric (English)
Water Pump Bolt
  • First Pass:
10 N.m (89 lb in)
  • Second Pass:
10 N.m (89 lb in)
  • Final Pass:
45 Degrees
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Coolant Recovery Reservoir Bolt 5 N.m (44 lb in)
Drain Plug 22 N.m (16 lb ft)
Engine Oil Cooler Fitting 24 N.m (18 lb ft)
Fan Shroud Mounting Bolt 10 N.m (89 lb in)
Radiator Mounting Bolt 10 N.m (89 lb in)
Thermostat Housing Bolt 10 N.m (89 lb in)
Thermostat Housing Retainer Bolt 50 N.m (37 lb ft)
Water Outlet Housing Bolt 10 N.m (89 lb in)
Water Pump Pulley Bolt 10 N.m (89 lb in)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.