2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Electronic Compass Module Replacement

Fig 1: Electronic Compass Module
GM2133361Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Lower the rear of the headliner to gain access to the module. Refer to Headlining Trim Panel Replacement .
1 Electronic Compass Module

Procedure

  1. Disconnect the electrical connectors.
  2. For programming and set up information, refer to Control Module References .
  3. Unsnap the electronic compass module from the rear of the panel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.