Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Accessory Wiring Junction Block Nut | 22 N.m (16 lb ft) |
| Air Conditioning Liquid Line Clamp Bolt | 9 N.m (80 lb in) |
| Battery Cover Screw | 1.6 N.m (14 lb in) |
| Battery Hold Down Bolt | 25 N.m (18 lb ft) |
| Battery Negative Cable Extension Cable to Cylinder Head Bolt | 58 N.m (43 lb ft) |
| Battery Negative Cable Extension Cable to Left Wheelhouse Panel Upper Reinforcement Bolt | 58 N.m (43 lb ft) |
| Battery Positive Junction Block Cable to Generator Nut | 22 N.m (16 lb ft) |
| Coolant Recovery Reservoir Bolt | 5 N.m (44 lb in) |
| Generator Bolt | 50 N.m (37 lb ft) |
| Generator Nut | 58 N.m (43 lb ft) |
| Generator Stud | 9 N.m (80 lb in) |
| Negative Battery Cable Ground Bolt | 25 N.m (18 lb ft) |
| Negative Battery Cable Terminal Nut | 9 N.m (80 lb in) |
| Positive Battery Cable Terminal Nut | 9 N.m (80 lb in) |
| Starter Bolt | 58 N.m (43 lb ft) |
| Starter Heat Shield Bolt | 4.7 N.m (42 lb in) |
| Starter Solenoid BAT Terminal Nut | 10 N.m (89 lb in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.