Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and ConnectionΒ .
- Remove the drive belt. Refer to Drive Belt Replacement .
- Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
- Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
- Remove the air conditioning (A/C) liquid line clamp fastener (2) from the upper radiator support.
- Remove the coolant recovery reservoir fasteners (1).
- Remove the reservoir (2) tabs from the upper radiator support, position the reservoir out of the way.
- Reposition the battery positive junction block cable boot (1).
- Remove the battery positive junction block cable to generator fastener (2).
- Remove the battery positive junction block cable terminal (3) from the generator stud.
- Disconnect the engine wiring harness electrical connector (1) from the generator (2).
- Loosen the idler pulley (1) fastener and slide the pulley out as far as possible.
- Remove the generator mounting fasteners (3) and generator mounting studs (2), if necessary.
- Remove the power steering fluid reservoir hose clip bracket (1) from against the generator.
- Remove the generator (4) and idler pulley (5) together from the vehicle.
- Remove the idler pulley from the generator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
