2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Wheel Speed Sensor Bolt
    GM1861969Courtesy of GENERAL MOTORS COMPANY
  1. Install the wheel speed sensor to the wheel knuckle.
  2. CAUTION:

    Refer to Fastener Caution .

  3. Install the wheel speed sensor bolt.

    Tighten 

    Tighten the bolt to 9 N.m (80 lb in).

  4. Fig 2: Wheel Speed Sensor Wire Harness Routing Clip
    GM1861966Courtesy of GENERAL MOTORS COMPANY
  5. Install the wheel speed sensor wire harness routing clips to the upper suspension link.
  6. Fig 3: Wheel Speed Sensor Electrical Connector
    GM1861964Courtesy of GENERAL MOTORS COMPANY
  7. Install the wheel speed sensor wire harness routing clips (3) to the upper suspension link.
  8. Install the wheel speed sensor wire harness grommet (2) to the lower control arm bracket.
  9. Connect the wheel speed sensor electrical connector (1).
  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Perform the Diagnostic System Check - Vehicle .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.