2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: BPMV Insulators
    GM1866321Courtesy of GENERAL MOTORS COMPANY
  1. Install the 2 BPMV insulators to the BPMV.

    Denatured alcohol may be used as an assembly aid to install the insulators.

  2. Install the lower BPMV insulator to the bracket.

    Denatured alcohol may be used as an assembly aid to install the insulator.

  3. Carefully install the BPMV to the bracket.

    Denatured alcohol may be used as an assembly aid on the insulators to install the BPMV.

  4. Fig 2: BPMV Insulator Nuts & Washers
    GM1866319Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.