Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Door Window Regulator Bolt | 10 N.m (89 lb in) |
| Door Window Regulator to Door Bolt | 10 N.m (89 lb in) |
| Door Window Regulator Motor Bolt | 5 N.m (44 lb in) |
| Door Window Regulator Motor Nut to Door | 9 N.m (80 lb in) |
| Door Window Regulator Motor Stud Bolt | 5 N.m (44 lb in) |
| Front Side Door Outer Sealing Strip Panel Screw | 1.5 N.m (13 lb in) |
| Front Side Door Window Lower Reveal Molding Screw | 5 N.m (44 lb in) |
| Front Side Door Window Rear Channel Bolt | 10 N.m (89 lb in) |
| Front Side Door Window Rear Channel Upper Screw | 10 N.m (89 lb in) |
| Front Side Door Window Weatherstrip/Run Channel Retaining Bolt | 10 N.m (89 lb in) |
| Rear Door Window Guide Bolt | 10 N.m (89 lb in) |
| Rear Side Door Outer Sealing Strip Panel Screw | 1.5 N.m (13 lb in) |
| Rear Side Door Outer Sealing Strip Screw | 1.5 N.m (13 lb in) |
| Rear Side Door Stationary Window Front Bolt | 10 N.m (89 lb in) |
| Rear Side Door Stationary Window Rear Bolt | 10 N.m (89 lb in) |
| Rear Side Door Stationary Window Upper Screw | 5 N.m (44 lb in) |
| Rear Side Door Window Front Channel Bolt | 9 N.m (80 lb in) |
| Rear Side Door Window Reveal Molding Lower Screw | 5 N.m (44 lb in) |
| Rear Side Door Window Upper Reveal Molding Lower Push Pin | 5 N.m (44 lb in) |
| Rear Switch Plate Screw | 2 N.m (18 lb in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.