2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Open the hood.
  2. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (Traverse)Windshield Wiper Arm Replacement (Acadia)Windshield Wiper Arm Replacement (Enclave) .
  3. Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  4. Remove the remote control door lock receiver. Refer to Remote Control Door Lock Receiver Replacement .
  5. Remove the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
  6. Remove the windshield garnish molding. Refer to Windshield Garnish Molding Replacement - Left Side , and Windshield Garnish Molding Replacement - Right Side .
  7. WARNING:

    If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

  8. Cover to protect the following parts from broken glass:
    • Upper dash pad
    • Defroster outlets and A/C outlets
    • Seats and carpeting
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.