Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the liftgate window into the opening. Refer to Adhesive Installation of Liftgate Windows .
- Install the rear window wiper arm. Refer to Rear Window Wiper Arm Replacement (Acadia)Rear Window Wiper Arm Replacement (Traverse)Rear Window Wiper Arm Replacement (Enclave) .
- Connect the liftgate window defogger electrical connectors to the bus bar.
- Install the liftgate trim. Refer to Liftgate Trim Panel Replacement (Traverse)Liftgate Trim Panel Replacement (Enclave)Liftgate Trim Panel Replacement (Acadia) .
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Close the liftgate.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.