2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Steering Wheel Control Switch Assembly Replacement (Traverse)

Fig 1: Steering Wheel Control Switch Assembly (Traverse)
GM2392835Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the inflatable restraint steering wheel module. Refer to Airbag Steering Wheel Module Replacement .
  2. Remove the steering wheel. Refer to Steering Wheel Replacement
1 Steering Wheel Rear Cover Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .
2 Steering Wheel Rear Cover
3 Steering Wheel Spoke Cover Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .
4 Steering Wheel Spoke Cover (Qty: 2)
TIP:  Use a flat-bladed plastic tool to disengage the 2 detent tabs and carefully pull cover from the 2 retainers.
5 Steering Wheel Control Switch Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .
6 Steering Wheel Control Switch Assembly (Qty: 2)

Procedure

  1. Radio control switch assembly is shown. Cruise control switch assembly is similar.
  2. Disconnect the electrical connector.
Chapter Navigation
Return to Chapter: Repair Instructions
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.