Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Suburban 3500 HD LSFACTORY OEM SERVICE PROCEDURE
Cruise Control System - DTCS
CRUISE CONTROL SYSTEM - DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B3623 | Steering Wheel Controls Distance Sensing Cruise Control Gap Up/Down Signal Circuit |
| DTC C0460 | Steering Wheel Angle Sensor Module - Incorrect Component Installed (Distance Sensing Cruise Control) |
| DTC C0561 | Driven Wheel Speed - Non Driven Wheel Speed Not Plausible |
| DTC C0565 | Vehicle Identification Number Malfunction |
| DTC C056E | Electronic Control Unit Software - Calibration Not Learned (Distance Sensing Cruise Control) |
| DTC C1002 | Distance Sensing Cruise Control Module Performance |
| DTC P0571 | Cruise Control Brake Switch Circuit |
| DTC P0572 or P0573 | Brake Switch Circuit 1 Low/High Voltage |
| DTC P0575 | Cruise Control Switch Signal Message Counter Incorrect |
| DTC P0703 | Brake Switch Signal Message Counter Incorrect |
| DTC P1553 | Distance Sensing Cruise Control Signal Message Counter Incorrect |
| DTC P158A | Cruise Control Calibration Incorrect |
| DTC P15F6 | Front Object Detection Control Module Torque Request Signal Message Counter Incorrect (Distance Sensing Cruise Control) |
| DTC B3794, P0564, P0565, P0567, P0568, P056C, P0580, P0581, P155A, P155C, or P162C | Cruise Control Malfunction |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.