2017 Chevrolet Suburban 3500 HD LSFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Trailer Brake Control Switch
    GM3634329Courtesy of GENERAL MOTORS COMPANY
  1. Install the trailer brake control switch (1) to the instrument panel accessory bezel.
  2. Ensure the locking tabs on the trailer brake control switch are fully engaged in the bezel.
  3. Fig 2: Switch Levers
    GM3634327Courtesy of GENERAL MOTORS COMPANY
  4. Carefully install the switch levers (1) into the trailer brake control switch.
  5. Ensure the switch levers are securely seated in the trailer brake control switch.
  6. Connect the electrical connectors and install the instrument panel accessory bezel. Refer to Instrument Panel Accessory Bezel Replacement (Chevrolet/GMC)Instrument Panel Accessory Bezel Replacement (Cadillac) .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.