Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE
HVAC System - DTCS: Automatic
HVAC - AUTOMATIC DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B0163, B0183 or B1405 | Passenger Compartment Temperature Sensor Circuit/Solar Load Sensor Circuit/Control Module Voltage Reference Output 2 Circuit |
| DTC B0173, B0178 or B3933 | Upper Left Duct Air Temperature Sensor Circuit/Lower Left Duct Air Temperature Sensor Circuit/Air Conditioning Evaporator Temperature Sensor Circuit |
| DTC B018A, B048C, B048F or B1395 | Windshield Temperature Sensor Circuit/Humidity Sensor Humidity Circuit/Humidity Sensor Temperature Circuit/Control Module Voltage Reference Output Circuit |
| DTC B0193 | Front Blower Motor Speed Circuit |
| DTC B0223, B0228, B0233, B0408, B0413, B0418, B0423, B1395 or B374A | Recirculate Position Command 1 Circuit/Left Recirculate Position Feedback Circuit/Air Flow Control Circuit/Main Temperature Control Circuit/Main Temperature Control Feedback Circuit/Control Module Voltage Reference Output Circuit/Air Flow Control Feedback Circuit |
| DTC P0532 or P0533 | Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit Voltage |
| DTC P0645, P0646 or P0647 | Air Conditioning (A/C) Compressor Clutch Relay Control Circuit |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
