2017 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Headlamp Control Module Replacement

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
GM2371563
Callout Component Name

Preliminary Procedures

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove instrument panel lower trim panel. Refer to Instrument Panel Lower Trim Panel Replacement - Left Side .
  3. Unclip instrument panel wiring harness fuse block.
  4. Unclip body wiring harness.
1 Headlamp Control Module

Procedure

  1. Disconnect electrical components.
  2. After repairs, refer to Control Module References for programming and set up information.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.