Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Single Use Non-Threaded Fasteners/Components
| Application |
|---|
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β
|
| Catalytic Converter Gasket |
Reusable Threaded Fastener Tightening Specifications
| Application | Specification |
|---|---|
| Metric (English) | |
|
NOTE:
All fasteners listed in this table can be reused after removal.Β
|
|
| Catalytic Converter Bracket Bolt | 22 N.m (16 lb ft) |
| Catalytic Converter Heat Shield Bolt | 9 N.m (80 lb in) |
| Catalytic Mounting Nut | 22 N.m (16 lb ft) |
| Catalytic Converter Nut | 22 N.m (16 lb ft) |
| Exhaust Front Heat Shield Nut | 1 N.m (9 lb in) |
| Exhaust Muffler to Catalytic Converter Nut | 22 N.m (16 lb ft) |
| Exhaust Rear Muffler to Exhaust Muffler Nut | 43 N.m (32 lb ft) |
| Surge Tank Fixing Bolt | 5 N.m (44 lb in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
