2017 Chevrolet Spark LS, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Steering Column Lock Control Module (1) @ Steering Column - Install
    Fig 1: Steering Column Lock Control Module
    GM4549003Courtesy of GENERAL MOTORS COMPANY
  2. Steering Column Lock Control Module Bolt-Side (1) - Install and tighten [2x] 9 N.m (80 lb in)
    Fig 2: Steering Column Lock Control Module Bolt-Side
    GM4549002Courtesy of GENERAL MOTORS COMPANY
  3. Steering Column Lock Control Module Bolt-Front (1) - Install NEW [2x]
    Fig 3: Steering Column Lock Control Module Bolt-Front
    GM4549001Courtesy of GENERAL MOTORS COMPANY

    Tighten the bolts until the bolt heads break off.

  4. Electrical Connector (1) @ Steering Column Lock Control Module - Connect
    Fig 4: Electrical Connector And Steering Column Lock Control Module
    GM4549000Courtesy of GENERAL MOTORS COMPANY
  5. Steering Column Lower Trim Cover - Install - Steering Column Lower Trim Cover ReplacementΒ 
  6. Steering Column Upper Trim Cover - Install - Steering Column Upper Trim Cover ReplacementΒ 
  7. Program the steering column lock control module. Refer to Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.