2017 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Steering Gear Boot Seal
    GM3539893Courtesy of GENERAL MOTORS COMPANY
  1. Install the steering gear boot seal (1) on the steering gear housing.

    Apply a small amount of Lithium Grease or equivalent to the seal before installing.

  2. Fig 2: Steering Gear Boot & Inner Clamp
    GM3533491Courtesy of GENERAL MOTORS COMPANY
  3. Position a NEW steering gear boot inner clamp (1) and steering gear boot (2) on the steering gear.

    Apply a small amount of Lithium Grease or equivalent to the inside of both ends of the steering gear boot before installing.

  4. Use the CH-22610Β  pliers to crimp the steering gear boot inner clamp (1).
  5. Fig 3: Steering Linkage Inner Tie Rod Nut & Steering Gear Boot Outer Clamp
    GM3533487Courtesy of GENERAL MOTORS COMPANY
  6. Install the steering gear boot outer clamp (2).
  7. NOTE:
    • Align the match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod previously recorded.
    • Do NOT tighten the steering linkage inner tie rod nut during installation. Tighten the nut after adjusting the front toe.
  8. Install the steering linkage inner tie rod nut (1).
  9. Install Steering Linkage Outer Tie Rod - Steering Linkage Outer Tie Rod ReplacementΒ 
  10. Measure and adjust the front toe. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.