Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- When major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
- When performing work in the engine compartment or under the vehicle, ensure that the hood is fully open, or opened to its secondary latch. When the hood is opened to the secondary latch, the vehicle will disable the remote start features from the key fob and OnStar mobile app. Failure to open the hood, or open the hood to the secondary latch while doing a repair in the engine compartment or under the vehicle can result in inadvertent vehicle starting which could result in personal injury or damage to a vehicle.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Install the left post-catalytic converter HO2S. Refer to Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 .
- Install the right post-catalytic converter HO2S. Refer to Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 .
- With the aid of an assistant, or using a suitable jack; position the exhaust muffler assembly to the vehicle.
- Align the exhaust system to the center exhaust isolator hanger bracket to differential retaining stud (1).
- Install NEW seals (2) to the left and right catalytic converter flanges.
- Install the exhaust muffler (4) into the exhaust isolators (3) and align the muffler to the left and right catalytic converters.
- Tighten the NEW fasteners (1) to 40 N.m (30 lb ft).
- Remove the jack supporting the exhaust system.
- Install the center insulator hanger bracket to differential retaining nut (1) and tighten to 45 N.m (33 lb ft).
- Connect the left post-catalytic converter HO2S electrical connector (1).
- Connect the right post-catalytic converter HO2S electrical connector (1).
- Install the underbody brace (1).
- Install the underbody brace mounting fasteners (2) and tighten to 58 N.m (43 lb ft).
- Install the rear exhaust isolator hanger brackets (2) and tighten the fasteners (1) to 22 N.m (16 lb ft).
- Make sure that the exhaust system is clear of all other components and chassis. If the exhaust system is not clear of all the other components loosen all retaining nuts and re-align. Refer to Exhaust System AlignmentΒ .
- Lower the vehicle.
- Start the vehicle and check for exhaust leaks.
WARNING:
To avoid any vehicle damage, serious personal injury or death:
CAUTION:
Refer to Fastener Caution .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
