Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and ConnectionΒ .
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
- Remove the accessory drive belt from the generator. Refer to Drive Belt Replacement - Accessory .
- Disconnect the electrical connector (3) from the generator.
- Reposition the protective boot (2) and remove the generator B + fastener (1).
- Remove the battery positive cable from the generator stud.
- Remove the fastener (5) securing the generator rear brace (4) to the back of the generator.
- Remove the generator mounting fasteners (1) and remove the generator (2) from the engine compartment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
