2017 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE

Generator Bracket Replacement (LS3)

Fig 1: Generator Bracket (LS3)
GM3274756Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the generator. Refer to Generator Replacement (LS3) .
  2. Remove the lower idler pulley. Refer to Drive Belt Idler Pulley Replacement .
1 Generator Bracket Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
58 (43 lb ft)
2 Generator Bracket
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.