Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Malibu LSFACTORY OEM SERVICE PROCEDURE
Object Detection And Pedestrian Protection System - DTCS
OBJECT DETECTION AND PEDESTRIAN PROTECTION - DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B094B or B094C | Object Detection Control Module |
| DTC B094D or B094E | Object Detection Indicator Circuit |
| DTC B0954, B0955, B0956 or B0957 | Parking Assist Front Sensor |
| DTC B095D or B095E | Parking Assist Rear Sensor Side Circuit |
| DTC B0958, B0959, B0960 or B0961 | Parking Assist Rear Sensor Circuit |
| DTC B0967 or B0968 | Parking Assist On/Off Switch |
| DTC B096B | Parking Assist Switch Parallel Parking Circuit |
| DTC B096C or B096D | Parking Assist Side Sensor Front Circuit |
| DTC B0987 | Vehicle Direction Camera Indicator Circuit |
| DTC B1008 | Calibration Data Not Programmed |
| DTC B1011 | System Disabled Information Stored Malfunction |
| DTC B1015 | Vehicle Identification Number Information |
| DTC B101D | Electronic Control Unit Hardware (with Side Blind Zone Alert, UFT) |
| DTC B101E | Electronic Control Unit Hardware (with Pedestrian Impact Detection, B3T) |
| DTC B127B | Rearview Camera Input Signal Circuit Missing Reference |
| DTC B1405 | Control Module Voltage Reference Output 2 Circuit |
| DTC B356A | Vehicle Direction Warning Switch Circuit |
| DTC B390A | Short Range Object Sensor Performance |
| DTC B390C | Long Range Radar Sensor Module |
| DTC B390D | Frontview Camera Module |
| DTC P15F6 | Front Object Detection Control Module Torque Request Signal Message Counter Incorrect |
| DTC P15F7 | Rear Object Detection Control Module Torque Request Signal Message Counter Incorrect |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.