2017 Chevrolet Cruze LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Transmission Mount, Body Wiring Harness Connector, Engine Control Module And Electronic Brake Control Module Bracket Bolts
    GM3680284Courtesy of GENERAL MOTORS COMPANY
  1. Install the engine control module and electronic brake control module bracket (1) to the transmission mount (4).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the 2 engine control module and electronic brake control module bracket bolts (2, 6) and tighten to 12 N.m (106 lb in).
  3. Clip in the body wiring harness connector (5).
  4. Install Body Wiring Harness (3)
    5. Fig 2: Engine Wiring Harness And Electronic Brake Control Module Bracket
    GM3707209Courtesy of GENERAL MOTORS COMPANY
  5. Clip in the engine wiring harness (1) to the engine control module and electronic brake control module bracket (3).
  6. Clip in battery positive and negative cable (3) from the engine control module and electronic brake control module bracket (1).
    7. Fig 3: Body Wiring Harness Connector And Electronic Brake Control Module Bracket
    GM3680283Courtesy of GENERAL MOTORS COMPANY
  7. Install Engine Wiring Harness (1)
  8. Connect the engine wiring harness connector (4) to the body wiring harness connector (3).
  9. Clip in the body wiring harness connector (3) to the engine control module and electronic brake control module bracket (2)
  10. Install Engine Control Module Bracket Replacement 
Chapter Navigation
Return to Chapter: Engine Control Module and Electronic Brake Control Module Bracket Replacement
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.