2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Application Specification
Metric (English)
Steering Linkage Outer Tie Rod Nut
  • First Pass:
 35 N.m (26 lb ft)
  • Final Pass:
 30 - 45 degrees
Electric Belt Drive Rack and Pinion Steering Gear Bolt and Nut
  • First Pass:
 55 N.m (41 lb ft)
  • Final Pass:
 150 - 165 degrees
Front Stabilizer Shaft Bolt
  • First Pass:
 22 N.m (16 lb ft)
  • Final Pass:
 30 - 45 degrees
Drivetrain and Front Suspension Cradle Rear Bolt
  • First Pass:
 100 N.m (74 lb ft)
  • Final Pass:
 90 - 105 degrees
Transmission Mount Strut Bolt
  • First Pass:
 100 N.m (74 lb ft)
  • Final Pass:
 90 - 105 degrees
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal. 
Application Specification
Metric (English)
Steering Gear Heat Shield Bolt 9 N.m (80 lb in)
Steering Linkage Inner Tie Rod 85 N.m (63 lb ft)
Steering Linkage Inner Tie Rod Nut 60 N.m (44 lb ft)
Drivetrain and Front Suspension Cradle Front Bolt 100 N.m (74 lb ft)
Front Suspension Crossmember Extension to Front Suspension Cradle Bolt 58 N.m (43 lb ft)
Exhaust Muffler Insulator Nut 22 N.m (16 lb ft)
Stabilizer Shaft Link Nut 65 N.m (48 lb ft)
Chapter Navigation
Return to Chapter: Specifications
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.