2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 2.03 OZS. 0.06 L PAG 46 S
Air Cond Refrigerant w/R-1234yf 1.06 LBS. 0.48 KG R-1234yf S
Air Cond Refrigerant w/R-134a 1.15 LBS. 0.52 KG R-134a S
Automatic Transmission Fluid Trans Mfr CD 6T35/MNU Drain and Fill with Use of Drain Plug N/A N/A Automatic Transmission Fluid DEXRON VI Fluid Capacity is between: 4.2 - 6.3 qts. S
Automatic Transmission Fluid Trans Mfr CD 6T35/MNU Overhaul N/A N/A Automatic Transmission Fluid DEXRON VI Fluid Capacity is between: 8.5 - 9.0 qts. S
Automatic Transmission Fluid Trans Mfr CD 6T35/MNU Valve Body Cover Removal N/A N/A Automatic Transmission Fluid DEXRON VI Fluid Capacity is between: 5.3-7.4 qts. S
Brake Fluid 1.06 QTS. 1 L DOT 3 Hydraulic Brake Fluid S
Engine Coolant 1.4L Eng 6.32 QTS. 5.98 L 50/50 mixture of DEX-COOL and clean, drinkable water S
Engine Oil 1.4L Eng w/Filter 4.20 QTS. 3.97 L API - SAE 5W-30 Use only engine oil licensed to the dexos1 specification, or equivalent, of the proper SAE viscosity grade. ACDelco dexos1 Synthetic Blend is recommended. If in an area of extreme cold, where the temperature falls below -20Deg.F (-29Deg.C), an SAE 0W-30 oil may be used. An oil of this viscosity grade will provide easier cold starting for the engine at extremely low temperatures. S
Fuel Tank Gas 13.70 GALS. 51.86 L S
Manual Transmission Fluid New Transmission 1.37 QTS. 1.29 L Manual Transmission Fluid GM Part No. 19259104. S
Manual Transmission Fluid Re-Manufactured Transmission 1.98 QTS. 1.87 L Manual Transmission Fluid GM Part No. 19259104. S
Manual Transmission Fluid Refill 1.86 QTS. 1.76 L Manual Transmission Fluid GM Part No. 19259104. S
Windshield Washer Fluid 2.65 QTS. 2.5 L Windshield Washer Fluid Follow the Manufacturer's Instructions for the mixture ratio. Automotive windshield washer fluid that meets regional freeze protection requirements. S
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.