Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Lubricate the valve lifter follower (1) with engine oil.
- Install valve lifter follower (1) into the head bore aligning the guide pins with the grooves in the fuel pump head bore prior to installing the gauge.
- Install the EN-51365 gauge (2).
- With help of an assistant rotate the crankshaft until the EN-51365 gauge (2) is flush with the cylinder head. This indicates the camshaft lobe is at the base circle position.
- Remove the EN-51365 gauge (2).
- Remove Valve Lifter Follower (1)
- Lubricate the valve lifter follower (1) with engine oil.
- Install valve lifter follower (1) into the head bore aligning the guide pins with the grooves in the fuel pump head bore..
- Install NEW Fuel Pump Seal (2)
- Install Fuel Pump (3)
- Install the 2 fuel pump bolts (4) alternating in steps of 1/2 turn.
- Fuel Pump Bolt (4) - Tighten 2.5 N.m (18 lb ft)
- Remove the EN-6015 plugs from all connections.
- Connect Fuel Feed Front Pipe (1) @Fuel Pump (2) Metal Collar Quick Connect Fitting Service
- Install Fuel Pump Insulator (3)@Fuel Pump (1)
- Connect the electrical connector.(2)
- Install Engine Wiring Harness Bracket (2)
- Install Engine Wiring Harness Bracket Bolt (1) and tighten 9 N.m (80 lb in)
- Install Fuel Feed Intermediate Pipe Fuel Feed Intermediate Pipe Replacement - High Pressure
- Install Engine Wiring Harness (3)
- Install Engine Wiring Harness Clip (1, 2)
- Connect the camshaft position sensor electrical connector.(5)
- Connect Electrical Connector (4) @Fuel Injection Fuel Rail
- Connect Charge Air Cooler Outlet Air Hose@Throttle Body Charge Air Cooler Outlet Air Hose Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Perform the scan tool learn/reset function:Control Module References .
NOTE:
The valve lifter follower (1) must be used in conjunction with the gauge (2) to fine the base circle of the camshaft.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
