Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Remove Engine Control Module Bracket Replacement
- Clip out the body wiring harness connector (3) from the engine control module and electronic brake control module bracket (2).
- Disconnect the engine wiring harness connector (4) from the body wiring harness connector (3).
- Unclip Engine Wiring Harness (1)
- Clip out the engine wiring harness (1) from the engine control module and electronic brake control module bracket (3).
- Clip out battery positive and negative cable (2) from the engine control module and electronic brake control module bracket (3).
- Unclip Body Wiring Harness (3).
- Clip out the body wiring harness connector (5).
- Remove the 2 engine control module and electronic brake control module bracket bolts (2, 6).
- Remove the engine control module and electronic brake control module bracket (1) from the transmission mount (4).
Fig 3: Transmission Mount, Body Wiring Harness Connector, Engine Control Module And Electronic Brake Control Module Bracket Bolts
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.