2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Install Mass Airflow Sensor Replacement 
  2. Fig 1: Air Cleaner Assembly, Wiring Harness Clip And Mass Airflow Sensor Electrical Connector
    GM3680222Courtesy of GENERAL MOTORS COMPANY
  3. Install Air Cleaner Assembly (1)
  4. Install Wiring Harness Clip (2)
  5. Connect Mass Airflow Sensor Electrical Connector (3)
  6. Connect Air Cleaner Housing Drain Hose@Air Cleaner Outlet Duct - Air Cleaner Housing Drain Hose Replacement 
  7. Connect Air Cleaner Outlet Duct@Air Cleaner Assembly -Air Cleaner Outlet Duct Replacement 
  8. Install Rear Intake Air Duct Replacement 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.