2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Wireless Charging System Module Replacement

Fig 1: Wireless Charging System Module
GM4284282Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove Radio Cooling Duct. Refer to Radio Cooling Duct Replacement
1 Wireless Charging System Module Bolt (Qty: 4)
CAUTION:

Refer to Fastener Caution


Tighten 
2.5 N.m (22 lb in)
2 Wireless Charging System Module

Procedure

  1. Disconnect the electrical connector.
  2. When the replacement is completed, use a scan tool to perform the appropriate reset functions. Refer to Control Module References
Chapter Navigation
Return to Chapter: Repair Instructions
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.